基于步进频率正交信号的星载MIMO-GMTI雷达空时频处理研究

多发多收(MIMO)体制雷达综合采用多通道、多频技术,为解决星载GMTI面临的探测慢速运动目标和消除盲速估计等问题提供了有效途径。MIMO雷达工作的基础是有效的波形设计。因此,在分析正交波形性能的基础上,结合GMTI应用需求,建立了星载MIMO雷达步进频率正交信号的基本参数确定准则,研究了步进频率MIMO雷达空时频联合自适应处理的基本原理,通过仿真验证了MIMO雷达在杂波抑制和GMTI性能上的优势。     

应用锤击法的大型复合材料桁架结构段自由振动分析

复合材料桁架结构以其轻质和优异的力学性能应用于大型航天航空飞行器结构,其承载能力和振动特性是决定其应用效果的关键因素。本文考察了大型碳纤维/环氧复合材料方形截面桁架结构段的自由振动特性。采用锤击法实验测试得到了复合材料桁架结构段自由振动的模态和频率,并与有限元数值模拟结果进行对比分析,论证了锤击法测试振动特性在复合材料桁架结构上应用的可行性和准确性。     

基于能力的远程航空通信用频需求获取策略

提出一种基于能力的远程航空通信用频需求获取策略。分析了远程航空通信用频需求获取的基本思路。在此基础上,将远程航空通信用频需求自顶而下划分为任务需求、能力需求、效果需求3个层级,通过对层级进行定义和关系分析,给出基于能力的远程航空通信用频需求获取框架,最后对需求获取准则进行定义,得出一套较为科学有效的远程航空通信用频需求获取流程。     

系统频率偏差对同时全极化测量的影响及其校准

目标极化散射矩阵的精确测量是全极化雷达极化信息处理的前提和基础。基于正负线性调频信号，针对采用数字解线性调频处理的同时全极化测量体制雷达，分别推导了雷达中频频率偏差和采样频率偏差对同时全极化测量影响的数学模型，提出一种雷达中频频偏和采样频偏的联合估计与校准方法。仿真和实测数据表明：雷达系统频率稳定度会引起不同通道极化测量结果峰值位置和相对相位的变化，采用所提方法能够有效校正峰值偏移，补偿相位误差，提高目标极化散射矩阵测量的精度。     

A reusable planar triggered spark-gap switch batched-fabricated with PCB technology for medium-and low-voltage pulse power systems

Triggered spark-gap switch is a popular discharge switch for pulse power systems. Previous studies have focused on planarizing this switch using thin film techniques in order to meet the requirements of compact size in the systems. Such switches are one-shot due to electrodes being too thin to sufficiently resist spark-erosion. Additionally, these switches did not employ any structures in securing internal gas composition, resulting in inconsistent performance under harsh atmospheres. In this work, a novel planar triggered spark-gap switch (PTS) with a hermetically sealed cavity was batched-prepared with printed circuit board (PCB) technology, to achieve reusability with low cost. The proposed PTS was inspected by micro-computed tomography to ensure PCB techniques meet the requirements of machining precision. The results from electrical experiments demonstrated that PCB PTS were consistent and reusable with lifespan over 20 times. The calculated switch voltage and circuit current were consistent with those derived from real-world measurements. Finally, PCB PTS was used to introduce hexanitrostilbene (HNS) pellets in a pulse power system to verify its performance.     

Research on fuze microswitch based on corona discharge effect

Abnormal voltages such as electrostatic, constant current, and strong electromagnetic signals can erro-neously trigger operation of MEMS pyrotechnics and control systems in a fuze, which may result in casualties. This study designs a solid-state micro-scale switch by combining the corona gas discharge theory of asymmetric electric fields and Peek's Law. The MEMS switch can be transferred from "off" to"on" through the gas breakdown between the corona electrodes. In the model, one of the two electrodes is spherical and the other flat, so a non-uniform electric field is formed around the electrodes. The theoretical work is as follows. First, the relation among the radius of curvature of the spherical electrode, the discharge gap, and the air breakdown voltage is obtained; to meet the low voltage (30-60 V) required to drive the MEMS switch, the radius of curvature of the spherical electrode needs to be 10-50 μm and the discharge gap between the two electrodes needs to be 9-11 μm. Second, the optimal ratio ε is introduced to parameterize the model. Finally, the corona discharge structural parameters are determined by comparing the theoretical and electric field simulation results. The switch is then fabricated via MEMS processing. A hardware test platform is built and the performing chip tested. It is found that when the electrode gap is 9 μm, the electrostatic voltage is at least 37.3 V, with an error of 2.6% between the actual and theoretical air breakdown voltages. When the electrode gap is 11 μm, the electrostatic voltage is at least 42.3 V, with an error of 10.5% between the actual and theoretical air breakdown voltages. Both cases meet the design requirements.     

松耦合感应电能传输系统的设计

在建立感应电能传输系统互感模型的基础上,结合设计的小功率感应电源试验平台,分析了如何选择该系统的补偿拓扑和谐振频率.根据分析结果搭建了感应电源试验平台,并且通过实验,证明了该系统在额定负载下的输出功率最大.     

伽利略导航系统若干关键技术分析

分析了目前最新的卫星导航定位系统———伽利略系统所采用的若干关键技术.从卫星轨道布置方式、信号与频率设计方法、伪卫星技术及信号服务等几个方面与GPS进行了对比研究.研究结果表明,Galileo系统具有定位精度高、兼容性好、功能全等优点,在新一代导航系统中具有重要地位.     

对空气静电放电的频域研究

利用辐射电磁场的推迟势方程对空气静电放电的电磁场频谱进行了理论推导,对放电电流峰值和金属小环上的耦合电压峰-峰值进行了测量,使用数字存储示波器记录了放电电流和耦合电压的波形。利用测量结果对静电放电的电磁场频谱进行了理论计算,比较了不同放电电压下耦合电压的幅度谱和功率谱,结果表明:空气静电放电的能量主要集中在直流到2.0 GHz的频段内。     

电晕放电辐射信号分析的小波基函数选取

研究电晕放电辐射信号既有利于消除其危害又有助于加强对其利用。针对小波变换提出在不同情况下对不同类型的电晕放电进行分析时,选取小波基函数的方法,理论上可以通过信号与小波波形的匹配或者通过计算信号与小波相关系数的方法来确定,而在不确定放电类型时可进行实际分析。